Product Construction
| Backing | PE coated paper |
| Type of adhesive | type: acrylic |
tesa® 58685
tesa® 58685 400 µm radar absorber tape
Product Features
- Excellent absorption performance for 76 ~ 81GHz radar application.
- Great bonding performance keeps good connection and position on substrate.
Product description
excellent product design brings customer good absorption performance, and bringing customer very great adhesion performance for its positioning.
- Excellent absorption performance for 76 ~ 81GHz radar application.
- Great bonding performance keeps good connection and position on substrate.
Product details and specifications
Product Features
- Excellent absorption performance for 76 ~ 81GHz radar application.
- Great bonding performance keeps good connection and position on substrate.
Application Fields
single-sided radar absorber tape could be applied in automotive radar system for absorbing reflected interference signals for more accurate detection signal receiving.
suitable for radio frequency 76 ~ 81 GHz, reflection loss no higher than -12dB with tape laminated onto waveguide plate.
Extraordinary peel adhesion meets automotive dynamic motion requirement for keeping it position.
suitable for radio frequency 76 ~ 81 GHz, reflection loss no higher than -12dB with tape laminated onto waveguide plate.
Extraordinary peel adhesion meets automotive dynamic motion requirement for keeping it position.
Product Construction
| Backing | PE coated paper |
| Type of adhesive | type: acrylic |
Properties / Performance Values
| Release of liner | easy |
| Temperature resistance (125°C) | very good |
| Density | 0.0445 g/cm³ |
| Surface resistance x-y-direction (adhesive) | 34000 Ohm / square |
| Temperature resistance (-40°C) | very good |
Properties / Performance Values
| Release of liner | easy |
| Temperature resistance (125°C) | very good |
| Density | 0.0445 g/cm³ |
| Surface resistance x-y-direction (adhesive) | 34000 Ohm / square |
| Temperature resistance (-40°C) | very good |
Adhesion to Values
| Adhesion to Aluminium (20 min. @ RT, 90°) | 7 N/cm |
| Adhesion to Steel (initial) | 11 N/cm |
| Adhesion to Steel (20min @ RT, 90°) | 15 N/cm |
Adhesion to Values
| Adhesion to Aluminium (20 min. @ RT, 90°) | 7 N/cm |
| Adhesion to Steel (initial) | 11 N/cm |
| Adhesion to Steel (20min @ RT, 90°) | 15 N/cm |
Additional Info
The values in this section should be considered representative or typical only and should not be used for specification purposes.
tesa® products prove their impressive quality day in, day out in demanding conditions and are regularly subjected to strict controls. All technical information and data above mentioned are provided to the best of our knowledge on the basis of our practical experience. They shall be considered as average values and are not appropriate for a specification. Therefore tesa SE can make no warranties, expressed or implied, including, but not limited to any implied warranty of merchantability or fitness for a particular purpose. The user is responsible for determining whether the tesa® product is fit for a particular purpose and suitable for the user’s method of application. If you are in any doubt, our technical staff will be glad to support you.
Downloads
Download the files below for more technical details and information on this product.
