Product Construction
| Color | yellow |
tesa® 60152 Adhesion Promoter PU/HPVC
Adhesion Promoter for PU
Product description
tesa® Adhesion Promoter is used to improve the adhesion of tesa® ACXplus tapes on polyurethane and hard PVC. Due to the different behaviors of the substrates, we recommend to test our Adhesion Promoter prior to usage.
tesa® Adhesion Promoter 60152 is UV traceable, because of UV pigments contained in the solution.
Product details and specifications
Application Fields
Recommended for PU and hard PVC.
Used to enhance the bonding strength and to reach higher peel adhesion values with our ACXplus tapes.
Used to enhance the bonding strength and to reach higher peel adhesion values with our ACXplus tapes.
Product Construction
| Color | yellow |
Properties / Performance Values
| Density | 0.76 g/cm³ |
| Viscosity | 9 mPa s |
| Consistency | liquid |
| Spreading rate ca. | 15 m²/l |
| Solids | 10 % |
Properties / Performance Values
| Density | 0.76 g/cm³ |
| Viscosity | 9 mPa s |
| Consistency | liquid |
| Spreading rate ca. | 15 m²/l |
| Solids | 10 % |
Additional Info
The bonding surface should be free of dust, grease, oil, moisture and other contaminants before using tesa® Adhesion Promoter 60152.
Clean the substrate with a lint free cloth and appropriate solvents, such as Ethanol or Isopropanol.
Then apply tesa® Adhesion Promoter 60152 thinly to the bonding surface, making sure that the entire surface is coated. The Adhesion Promoter can be applied with a lint free cloth or brush, application pen or felt applicator.
Wait 2 to 5 minutes to give the solvents time to evaporate.
Keep the prepared surface free from contaminants prior to applying tesa® ACXplus tape.
Open time for bonding are several hours/ days.
Shelf life are 12 month when stored in the original container at room temperature.
For all further information kindly refer to the respective material safety data sheet (MSDS).
http://www.tesa.com/company/safety/msds
Clean the substrate with a lint free cloth and appropriate solvents, such as Ethanol or Isopropanol.
Then apply tesa® Adhesion Promoter 60152 thinly to the bonding surface, making sure that the entire surface is coated. The Adhesion Promoter can be applied with a lint free cloth or brush, application pen or felt applicator.
Wait 2 to 5 minutes to give the solvents time to evaporate.
Keep the prepared surface free from contaminants prior to applying tesa® ACXplus tape.
Open time for bonding are several hours/ days.
Shelf life are 12 month when stored in the original container at room temperature.
For all further information kindly refer to the respective material safety data sheet (MSDS).
http://www.tesa.com/company/safety/msds
tesa® products prove their impressive quality day in, day out in demanding conditions and are regularly subjected to strict controls. All technical information and data above mentioned are provided to the best of our knowledge on the basis of our practical experience. They shall be considered as average values and are not appropriate for a specification. Therefore tesa SE can make no warranties, expressed or implied, including, but not limited to any implied warranty of merchantability or fitness for a particular purpose. The user is responsible for determining whether the tesa® product is fit for a particular purpose and suitable for the user’s method of application. If you are in any doubt, our technical staff will be glad to support you.
Downloads
Download the files below for more technical details and information on this product.
